Author: muri

The flow rate is roughly half of the equivalent size pump output, through a maximum discharge pressure of 200 PSI can be achieved with only 100 PSI air inlet pressure supplied. The 2:1 discharge ratio is achieved by applying air pressure to the surface area of both diaphragm, doubling the discharge Key AdvantagesNo elaborate bypass requiredNo Relief valves requiredNo complicated controls requiredGreat pressure retention Designed for applications where 100 PSI maximum pump operating pressure is insufficient to overcome system requirements.

By utilizing one pump, Yamada offers a design in which the inlet and outlet ports can be configurated to multilple combinations; ideal for pumping or combining two similar specific gravity fluids. For instance, a dual suction/single discharge split manifold pump could be used to mix two fluids, such as antifreeze and water. Moreover, if you need to pump two separate colors of ink to two separate locations, then a dual suction/dual discharge pump would be a great fit. General Pump … Continue reading “Split Manifold Diaphragm Pump YAMADA”

Specifically designed to move bulk solids more effectively throughout your process. They are a cost effective replacement for Augers and conveyors and eliminate unsafe and labor intensive means of moving bulk powders. These heavy duty pumps consistently transfer fine-grained (100 um of finer), low density (5 to 50 lbs/cubic foot), dry powders in a dust-free operation. Principles of Operation Conveying distance depends upon the micron size and te bulk density of the powder. For example fumed silica can be conveyed … Continue reading “Powder Diaphragm Pumps”

Design for Food, Pharmaceutical & cosmetic Industries. Pump include : 316 Stainless Steel wetted component with passivated satin finish, PTFE-Coated Air Motor, Sanitary Clamp Fittings, and FDA compliant elastomers: Hytel, EPDM and PTFE. Key FeaturesSelf-priming lube-free air valveExcellent for shear sensitive liquidsIntrinsically safe and portableAbility to run dry without pump damage Manufacturer specifically design for food, Pharmaceutical & Cosmetic industries where 3A or USA standards are not required.

Available in 1-1/2″, 2, and 3″ port sizes, XDP pumps are built on te liquid platform of a standard (pneumatically-actuated) NDP series pump. But with a mechanically-actuated air motor. Air power is conserved by actuating than air valve using a mechanical linkage insted of relying on air pressure. Air powered is reduced versus a standard air-actuated valve, providing higher pump efficiency. Process Pump Manufacture offers high pressure, extended deadheading, long runs of discharge pipe, and where ir consumption is critical.